The loading of a pallet in to a pallet gravity flow racking is executed from one side. Later then the pallet moves through the roller conveyor under the gravity on a controlled speed. The picking of pallets is executed on the opposite side of the racking. The pallet flow racking secures FIFO loading principle.

The bearing construction of a pallet flow racking is based on a reliable pallet racking system by IMVO. The roller conveyor is built in the drive-in pallet rack. These conveyors secure permanent speed movement of goods through the channel from the input to the picking point. Specific conveyor elements provide a pallet movement slow down, stopping and direction. Due to a tight warehousing the pallet flow racking may reach a 60% higher area use rate than the conventional wide isle pallet racking. The loading and picking areas separation increases the operational productivity.

 

The pallet flow racking is used in the following types of warehouse:

• Buffer storages for commissioning

• Distribution and assembling warehouses

 

 

IMVO applies various models of roller modules for different pallet types, loads and ambient conditions. The pallets are delivered smoothly on a controlled speed. Special mechanisms secure safe pallet stopping on the end of a channel. Technical data:  

- channel width: 1000mm (one pallet line), 2000mm ( two pallet lines), 3600mm ( three pallet lines) 

- channel depth: depends on a number of pallets 

- pallet weight: up to 1200kg 

- pallet height: up to 2000mm  

- rack height: up to 12m.  

Print or save in PDF
Save as PDF Print (preview)
Professional advice
0-800-50-46-50

Contacts

Tel. / Fax: +38 (032) 297-14-44 Lviv
Tel: +38 (044) 384-18-34 Kyiv
E-mail: stelag@imvo.lviv.ua

Join Us

Request a call

captcha
Reload

Leave your message en

captcha
Reload